/* Copyright 2020 Moritz Plattner This program is free software: you can redistribute it and/or modify it under the terms of the GNU General Public License as published by the Free Software Foundation, either version 2 of the License, or (at your option) any later version. This program is distributed in the hope that it will be useful, but WITHOUT ANY WARRANTY; without even the implied warranty of MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the GNU General Public License for more details. You should have received a copy of the GNU General Public License along with this program. If not, see <http://www.gnu.org/licenses/>. */ #pragma once #include "config_common.h" /* USB Device descriptor parameter */ #define VENDOR_ID 0x4C58 //"LX" #define PRODUCT_ID 0x0001 #define DEVICE_VER 0x0001 #define MANUFACTURER Lx3 #define PRODUCT Whale-75 /* Set 1 kHz polling rate and force USB NKRO */ #define USB_POLLING_INTERVAL_MS 1 #define FORCE_NKRO /* key matrix size */ #define MATRIX_ROWS 6 #define MATRIX_COLS 16 #define MATRIX_ROW_PINS { B3, B4, B5, B6, B7, A0 } #define MATRIX_COL_PINS { A1, A2, A3, A4, A5, A6, A7, B0, B1, B2, B10, B11, B12, B13, B14, B15 } #define UNUSED_PINS { C13, C14, C15 } /* COL2ROW, ROW2COL */ #define DIODE_DIRECTION COL2ROW #define DEBOUNCE 5 #define LED_NUM_LOCK_PIN A8 #define LED_CAPS_LOCK_PIN A9 #define LED_SCROLL_LOCK_PIN A13 #define LED_PIN_ON_STATE 0 /* Backlight */ #define BACKLIGHT_PIN A10 #define BACKLIGHT_BREATHING #define BACKLIGHT_PWM_DRIVER PWMD1 #define BACKLIGHT_PWM_CHANNEL 3 #define BACKLIGHT_PAL_MODE 6 #define BACKLIGHT_LEVELS 5 #define BACKLIGHT_ON_STATE 1 #define BACKLIGHT_PWM_OUTPUT_FREQUENCY 1000 // Increases backlight PWM freq if compiled with an unmerged PR. Does no harm without it. /* Underglow */ #define RGB_DI_PIN B9 #define WS2812_EXTERNAL_PULLUP // This board uses a pull-up + 5 V tolerant GPIO in open drain config ro generate a 5 V signal #define RGBLED_NUM 18 /* section for PWM WS2812 driver */ #define WS2812_PWM_DRIVER PWMD4 #define WS2812_PWM_CHANNEL 4 #define WS2812_PWM_PAL_MODE 2 #define WS2812_DMA_STREAM STM32_DMA1_STREAM7 #define WS2812_DMA_CHANNEL 7 #define RGBLIGHT_SLEEP #define RGBLIGHT_EFFECT_BREATHING #define RGBLIGHT_EFFECT_RAINBOW_MOOD #define RGBLIGHT_EFFECT_RAINBOW_SWIRL /* Rotary encoder - set the resolution fitting your encoder. Most will need a value of 4. If 1 encoder click results in 2 keycodes sent double the value. If you need 2 clicks for 1 keycode, half it */ #define ENCODER_RESOLUTION 2 #define ENCODERS_PAD_A { A15 } #define ENCODERS_PAD_B { A14 } #define TAP_CODE_DELAY 10