History

Ryan 023d644bb6 Move RGBLight animations to data driven (#21635 ) * Move RGBLight animations to data driven, 0-9 * Move RGBLight animations to data driven, A * Move RGBLight animations to data driven, B * Move RGBLight animations to data driven, C * Move RGBLight animations to data driven, D * Move RGBLight animations to data driven, E * Move RGBLight animations to data driven, F * Move RGBLight animations to data driven, G * Move RGBLight animations to data driven, H * Move RGBLight animations to data driven, handwired * Move RGBLight animations to data driven, I * Move RGBLight animations to data driven, J * Move RGBLight animations to data driven, K * Move RGBLight animations to data driven, L * Move RGBLight animations to data driven, M * Move RGBLight animations to data driven, N * Move RGBLight animations to data driven, O * Move RGBLight animations to data driven, P * Move RGBLight animations to data driven, Q * Move RGBLight animations to data driven, R * Move RGBLight animations to data driven, S * Move RGBLight animations to data driven, T * Move RGBLight animations to data driven, U * Move RGBLight animations to data driven, V * Move RGBLight animations to data driven, W * Move RGBLight animations to data driven, X * Move RGBLight animations to data driven, Y * Move RGBLight animations to data driven, Z * Fix incorrect placement * Fix build failures and mismatches		2023-08-23 22:11:39 +01:00
..
keymaps/default	Remove legacy keycodes, part 6 (#18740 )	2022-10-16 14:14:40 +01:00
rev1
rev2
config.h	Move RGBLight animations to data driven (#21635 )	2023-08-23 22:11:39 +01:00
halconf.h
info.json	Move RGBLight animations to data driven (#21635 )	2023-08-23 22:11:39 +01:00
mcuconf.h
readme.md
rules.mk	OLED: driver naming cleanups (#21710 )	2023-08-15 10:30:34 +01:00

readme.md

grandiceps

ARM split keyboard with RGB underglow and encoders.

Keyboard Maintainer: vattern
Hardware Supported: f411 blackpill
Hardware Availability: grandiceps

There are two versions of the Grandiceps. Please use the appropriate firmware for your board.

Revision 2 has I2C eeprom and support for a Pimoroni trackball.

Make example for this keyboard (after setting up your build environment):

make tkw/grandiceps:default
make tkw/grandiceps/rev2:default

Flashing example for this keyboard:

make tkw/grandiceps:default:flash
make tkw/grandiceps/rev2:default:flash

See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.

Bootloader

Enter the bootloader in 3 ways:

Bootmagic reset: Hold down the key at (0,0) in the matrix (usually the top left key or Escape) and plug in the keyboard
Physical reset buttons: Hold down the BOOT0 button and then briefly press the NRST button on the BlackPill PCB.
Keycode in layout: Press the key mapped to QK_BOOT if it is available