qmk_firmware/keyboards/jacky_studio/piggy60

Piggy60

A gasket-mounted 60% in the style of the S7 Elephant.

• Keyboard Maintainer: The QMK Community
• Hardware Supported: Piggy60 PCB "rev1" (atmega32u4)
  • Make sure your PCB uses an atmega32u4 before flashing! A PCB that uses an APM32F103CBT6 with uf2boot has been shipped with some extras purchases and to replace some defective units. Flashing that PCB with "rev1" firmware may result in a non-functional PCB which can only be recovered using a hardware programmer (e.g. an ST-Link V2)
• Hardware Availability: Group Buy took place between 2021-05-22 1600 UTC and 2021-05-25 1600 UTC on https://jackylab.com/.

Make example for this keyboard (after setting up your build environment):

make jacky_studio/piggy60:default

Flashing example for this keyboard:

make jacky_studio/piggy60:default:flash

See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.

Bootloader

Enter the bootloader in 3 ways:

• Bootmagic reset: Hold down the top left key and plug in the keyboard. This will also clear EEPROM, so it is a good first step if the keyboard is misbehaving.
• Physical reset: Short the set of vertical holes on the third row, to the right of Caps Lock. These can be reached with tweezers after the board has been assembled.
• Keycode in layout: There is no key mapped to QK_BOOT in the pre-created keymaps, but you may assign this key in any keymaps you create.